How do I apply a sticker without bubbles?
The secret of bubble-free application is a clean surface and pressing the sticker down gradually from one edge to the other. For a larger sticker, first fix its position with tape, remove the backing paper in parts and press the sticker down with a squeegee or a bank card.
What you need
- an application squeegee (a bank card also works);
- an alcohol-based cleaner without polishing agents;
- a microfibre cloth (paper can scratch paintwork);
- masking tape and a tape measure.
Preparing the surface
- Step 1: Clean the surface
Remove dirt, dust and grease. Clean a second time if needed.
- Step 2: Let it dry
Even a little moisture reduces adhesion.
- Step 3: Choose the right temperature
Apply at +10…+25 °C. Avoid hard frost and direct sunlight.
Application
- Step 1: Find the right spot
Measure the spot and fix the sticker, with its backing paper, to the surface with tape.
- Step 2: Remove part of the backing paper
Undo the tape on one edge and remove part of the backing paper there. Don't tear off all the backing paper at once.
- Step 3: Press the sticker down
Start from the edge and press the sticker onto the surface with the squeegee held at about 45 degrees. This pushes the air out from under the sticker.
- Step 4: Continue in parts
Remove the next part of the backing paper and repeat until the whole sticker is on the surface.
- Step 5: Press the edges down
On curves and edges work in small steps, and finally press the whole sticker firmly onto the surface.
